Vicon CE102D Guia de Instalação descarregar pdf (Página 54)

• NAT traversal Settings

- Enable: Click the Enable button to enable NAT traversal; pressing the button toggles

between enable and disable. When enabled, the network camera attempts to configure port

mapping in a NAT router on your network, using UPnP. Note that UPnP must be enabled in

the network camera (see System>Network>UPnP).

Enter a NAT router and enter the external port number for the router in the field provided.

If you enter o in those fields, the network camera automatically searches for NAT

routers on your network.

Notes:

- If you attempt to manually enter a port that is already in use, an alert message will be

displayed.

- When the port is selected automatically it is displayed in this field. To change this enter a

new port number and click Save.

When the settings are complete, click Save, or click Reset to revert to previously saved settings.

 Zeroconfig

Zeroconfig allows the network camera to create and assign IP address for network cameras and

connect to a network automatically.

Zero configuration networking (zeroconf), is a set of techniques that automatically creates a usable

Internet Protocol (IP) network without manual operator intervention or special configuration servers.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 70 71

Sem comentários

Vicon CE102D Guia de Instalação Página 54